Tank Details T11

Dimensions (TZ5) Milimeters Feet Inches
Length 6,058 19' 11"
Width 2,438 8' 0"
Height 2,591 8' 6"
Capacity Liters Imperial Gallons US Gallons
  24,000 5,281 6,340
  25,000 5,500 6,605
  26,000 5,720 6,870

Shell Material Stainless steel, A 240 316 (316533).
Frame Material Structural steel to BS 4360 Grade 50A, B & C.
Shell Thickness Shell and ends 4.47 mm and 4.70 mm respectively.

Working Pressure 4 Bar (58.0 psi)
Test Pressure
6 Bar (87.0 psi)
External Vacuum Pressure
0.41 Bar (5.9 psi)
Design Temperature -40/140C (248F)
Design Code ASME VIII Division 1

External Finish Framework shot blasted to SA 2.5 and painted using a vinyl co-polymer resin.
Internal Finish Better than 180 grit with the total interior acid cleaned, and certified for the carriage of foodstuff.

Weights Kgs. Lbs.
Max Gross 36,000 79,365
Tare 3,550 7,826
Max Payload 32,450 71,539


Manlid Fort Vale 500 mm, low profile fully hinged with 8-point fixing complete with stainless steel swing bolts with naval brass handnuts.

Air Line
1.5” BSP stainless steel ball valve fitted with an integral flame arrestor. Terminates in a 1.5" BSP dust cap with a retaining wire. Facility for pressure gauge connection exists.

Bottom Outlet 3" 45 deg combination bottom outlet. 3" foot valve with clamped 3" butterfly valve with 3" BSP threaded connector with stainless steel cap and retaining chain. Remote control connected to internal valve-kick cable type. Fusible link fitted when applicable.

Top 3” nominal bore for fitment of removable siphon tube, 3” butterfly valve Outlet and 3" Table 'D' blank flange. Safety Relief One 3" BSP "Super Maxi" high flow pressure relief valve set.

at 4.4 bar (63.8 psi). Provision for second SRV.

All top fittings are housed in two stainless steel spill boxes.

complete with stainless steel drain tubes.

Insulation 50 mm thick mineral wool. Complete outer cladding of 0.8mm thick aluminum marine grade 5754 mill finish with swaged joints.

Steam Heating
Comprising of 10 longitudinal stainless steel channels (2.5 x 2.5 x 100mm).

Effective heating area of 10 sq. meters (107sq. ft.) with 6 BAR (87 PSI) MAWP. Outlet: 3/4" BSP connection with plastic cap and retaining wire. Inlet: 1" BSP connection with plastic cap and retaining wire.

Thermometer One Contact type analog from -40ºC to 160ºC with dual ºF readings located at the rear end.

BV, ADR/RID, T-11 IMDG, IM101 (US) DOT, (UK) DOT, IMO Type 1, UIC, TIR, CSC, AAR 600, TC Impact Approved. FRA, DIR (Australia).